I’ve recently added a new section to the socalregion website. I noticed the site was lacking in resources for local roadways. In particular, information on how to contact various local agencies for road projects, logs, and maintenance. With this in mind, I’ve added a new page to help others get their roads fixed and find out more information about those roadways. I’ve called it the “Southern California Highway Resources” page, which can be found on the Southern California Highways page and via this link.
Concrete is a very durable material. It has many uses, though for our purposes – roadway surfaces, curbs, and sidewalks. Local roadways, such as concrete city streets, won’t be covered in this post. Bridges will be covered in a later post. This durability allows us to get either a relative date of when a roadway was paved or built to an absolute date when we find a date stamp.
Style of Paving
Short section of Roberts Rd that is now a driveway.
1920’s paving near Osborne St. Note the widening work that was done on the right side. Looking west.
As technology has evolved, so has concrete paving. The first concrete paving along State Highways was 10-12′ wide, usually not reinforced with steel. These roads were paved in one single slab of concrete. Roadways of this style were paved from around 1910 to 1915. After 1915, wider paving was used and was generally reinforced. Wider paving ran from 15′, 18′, and a “full” 20′. These are usually referred to as “Single Slab Paving”.
Sometime around 1923, longitudinal joints were added to the concrete paving. This created a “Twin Slab” roadway. This style persists today, though greatly changed. Early Twin Slab roadways had fewer expansion joints running across the lane. After around 1926, this problem was worked out by adding more frequent joints. By this time, each lane was a “standard” 10′. This standard remained until the late 1940’s when lane width started to widen to 12′.
Date Stamps
1948 date stamp on Olympic Blvd.
Contractors, either by requirement or pride, usually stamp the concrete roadway, curb, or sidewalk with a date stamp. These stamps vary in location, size, and information. California, at least on state contracts, required all concrete to be stamped starting in July 1924 (California Highways July 1924 Pg 7). Date stamps marked either the beginning or end of a days paving. As such, the stamp tended to be located near an expansion joint. A general rule with date stamps is “find one, you can find the rest”. This is mostly about the location. Some stamps are in the middle of a lane, some are to the side of a lane. The orientation also varies with stamps. The information contained in these stamps also varies. Early stamps just have the contractor and the date. Later stamps added the engineering station. Without going into too much detail, at this time, about engineering stations, the “zero” point is at the beginning of a road section or project. With little exception, I have had little success in finding a date stamp on Single Slab roadways. Twin Slab roadways are much better with stamps.
Using date stamps and styles as a guide, you can easily date a roadways construction to within a few years. There are other methods you can use, but these aren’t covered here. Some will be covered in later posts. Stay tuned for more posts. Bridges, Road Signs, and more will be covered in the future. If you have any questions, please post a comment or send me a message.
